M880 THOR2 M - OPTIONALS

ADD BOX DISPLAY

 

THOR2 M may be integrated with the ADD BOX option. This option will increase the number of commands on the transmitting units, allowing for the installation of further buttons, potentiometers, switches etc. according to specific requests. It is also suitable for hosting a large screen (available also with 128x64 or  TFT QVGA 3.5” display) or LED lights, in order to display data and/or alarms coming from the machine/system on which the radio remote controller is installed.
 

CONNECTION CONFIGURATION VIA SERIAL CABLE

 

The transmitting units of the ZEUS and THOR ranges may be equipped with a socket for serial connection to the receiving unit. With direct cable connection, radio transmission is by-passed. This helps avoid potential problems due to signal disturbances, dead battery or situations in which the product is used in areas where radiofrequencies are not permitted.
 

PWM APT400 ACTUATORS


APT400 electro-hydraulic actuators are compatible with KRON, ZEUS2 and THOR2 radio remote controls and allow you to operate most hydraulic cranes equipped exclusively with manual commands.
Since the system does not have to be welded to the push rods, the original machine configuration will remain unaltered.
The electro-hydraulic circuit of the APT400 system was separated from the crane system thanks to a dedicated electro-hydraulic control unit. This helps avoid potential malfunctions that might arise if the system shared the hydraulic circuit of the crane, which is typically already worn due to heavy work conditions.
The control unit is activated only when operations are performed via the radio remote control (“on demand” activation), thereby avoiding energy waste and reducing both wear and operating temperature.
APT 400 actuators are calibrated once the installation is completed, using the radio remote control transmitting unit.

To download the technical sheet, please click on the following link.

 
 

STROKE EXTENSION KIT


Thanks to a specific flange kit, APT400 actuators may be connected directly to Walvoil SD6-SD8, Galtech and Parker manual proportional distributors.

This configuration requires removing the push rods.

 
 

KIT ADAPTER


Thanks to a specific flange kit, APT400 actuators may be connected directly to Walvoil SD6-SD8, Galtech and Parker manual proportional distributors.

This configuration requires removing the push rods.

 
 

 

 

Multi-receiver and / or Multi-transmitter configuration 


IMET makes available to its users, special radio remote control configurations that allow, by a simple selection command, to macht one receiver with more than one transmitter or alternatively, severeal transmitters to one or more receivers. This is particulary useful when operating industrial cranes.
a) The available configuration are Tandem, Take/Release and Master/Slave, aimed at satisfying the most demanding operational requiremets.
b) Selectable receivers: allow to select from a single trnasmitter up to 8 receivers or 8 combinations of more recievers. 

 

Torna all'inizio pagina