M880 KRON - OPTIONALS
![]() |
PWM APT400 ACTUATORS
APT400 electro-hydraulic actuators are compatible with KRON, ZEUS2 and THOR2 radio remote controls and allow you to operate most hydraulic cranes equipped exclusively with manual commands. |
|
![]() |
STROKE EXTENSION KIT
The standard actuator stroke is of ±13 mm from the centre and is suitable for most hydraulic distributors available on the market. |
|
![]() |
ADAPTER KITThanks to a specific flange kit, APT400 actuators may be connected directly to Walvoil SD6-SD8, Galtech and Parker manual proportional distributors. This configuration requires removing the push rods. |
|
|
Multi-receiver and / or Multi-transmitter configuration
|
|
![]() |
Tilt SensorThe device can recognize unnatural inclination angles of the transmitting unit occuring in typical emergency situations (fall and trip over the radio remote control and/or loss of balance by the operator) |
|
![]() |
Wired remote control / Serial cableKRON transmitters can be equipped with wires serial connection to the receiver. The direct cable connection excludes the radio tranmission, overcoming any problem related to signal noise or to the use of the product in areas where radiofrequency is not permitted, or due to the exhaustion of the battery. |
|
![]() |
KAPTAKAPTA option allows to pair in few seconds a replacement of the units. For this purpose the transmitting units include a wireless reader and the receiving units come with a smart card. Executing a proper procedure the units can be paired permanently and with exclusive control. |
|
![]() |
BLACKLIT PANELThis option is available on all waist-belt type of transmitters and grants a perfect readability of the transmitter panel in gloom or low-light situations. |